uMaxum II Indicator (2034205)

μMaxμm II Indicator with SPC output Measuring Range: ±.040"/1mm Resolution: 0.0005" Accuracy: ±0.50mm / ±0.020” to ±1.00mm / ±0.040” Stem Diameter/Length: 0.375"/1.50” Flat Back

Availability: In stock

$528.00
OR

uMaxum II Indicator

Double click on above image to view full picture

Zoom Out
Zoom In

More Views

  • uMaxum II Indicator

Product Description

Standard Features: - Inch/Metric – operator selectable with switchable resolution. - Normal / Reverse Sensing - Preset capabilities to view actual size. - “Absolute” Transducer – no overspeed errors or constant re-zeroing. Transducer always remembers its location, even if power is off. - High resolution digital readout and analog bar graph digital display shows deviation from zero or actual dimension size - Lightweight, contamination resistant – ruggedly built to withstand hard use – gasketed case, crystal and stem assemblies resist fluid contamination. - Calibratable – if ever needed – values remembered even after battery change. - Marconnect data output: USB, OPTO RS232C, Digimatic - Auto-power down – provides extremely low battery consumption, assuring long life from readily available commercial batteries. - Increased resolution (0.0002mm / 10uinch) for today’s demanding tolerances. - Unilateral Tolerances - Go/NoGo Display Feature Advanced Functions: - Dynamic mode operation: - Max, Min, TIR - Two point difference measurement – provides comparison of two readings or measuring locations. - Calculate the distance between 2 measured values - Multiplier factor for ratio measurements - Hold function – holds reading on display until ready to resume measuring - Data output with serial number identification capability ID - Data output with selectable continuous output or single request of reading(s)

Additional Information

SKU 2034205
Weight (in lbs) 1.2
Manufacturer MahrFederal
Gage Type Indicator
Gage Cable C-1051-06
Measuring range ±.040"/1mm
Resolution 0.0005"
Accuracy ±0.50mm / ±0.020” to ±1.00mm / ±0.040”
Remarks Flat Back